Interesting Helicopter and Fixed-wing Facts for Hoover, AL

Once the engine fails or otherwise is shut off the pilot must immediately lower the pitch reducing lift and drag and the helicopter will begin to descend. If they dont do this quick enough allowing the RPM of the main rotor to drop too far theyll then lose control of the helicopter and will likely not get it back.

The AK1-3 was designed to comply with the Ukrainian AP-27 rules which are similar to the European Aviation Safety Agency CS-27 standard. The aircraft features a single main rotor with a tail rotor a two-seats-in side-by-side configuration enclosed cockpit skid-type landing gear and a four cylinder air-cooled four-stroke 156 hp (116 kW)Subaru EJ25 automotive engine.

Fun Helicopter and Airplane Facts for Hoover, AL

Become a commercial helicopter pilot: Apply for a flight instructor job at a flight school. An air ambulance company may require its pilots to have a minimum of 1000 hours flight time. Teaching people how to fly is a legitimate way of building up your flight hours.

FAA - A History of Aircraft Structures Factoid

There are five major stresses to which all aircraft are subjected: Bending. Bending stress is a combination of compression and tension. The rod in Figure 1-14E has been shortened (compressed) on the inside of the bend and stretched on the outside of the bend. A single member of the structure may be subjected to a combination of stresses. In most cases, the structural members are designed to carry end loads rather than side loads. They are designed to be subjected to tension or compression rather than bending.